Contact Us: 1-855-543-1511
Français

IDESIF


Welcome to Idesif!

VERTICAL WALL STICKER INSTALLATION INSTRUCTIONS

 

 

Step 1

 

Clean the surface. Ensure that the surface is dry and free from any dust or dirt.

 

If paint is fresh, wait two weeks before applying your wall decal to make sure it is dry. 

Installation instructions step 1


Step 2

 

Attach the decal to the wall by applying a single strip of masking tape horizontally to the top of the decal (the strip should cover both the sticker and the surface). This strip will be used as a support to keep the decal in place during the application process.

Installation instructions step 2

 

Step 3

 

Pull the bottom of the decal away from the wall, and remove the backing (starting at the top) to reveal the sticky side of the vinyl.

 

CAUTION: do not let the exposed decal touch the wall – the back of it is very sticky. If the decal is not properly aligned on the wall, it can be difficult to reposition it without causing damage to the vinyl.

Installation instructions step 3

 

Step 4

 

While holding the decal away from the wall surface, use a squeegee (a credit card is fine) to attach the decal to the surface. Begin at the top. Make sure to work from the centre of the decal outward, using firm strokes with the squeegee to force the air out from under the decal.

 

Note: Make sure to work from top to bottom. Do not allow the entire decal to touch the wall. If lines or creases develop, gently lift and reposition the decal.

Installation instructions step 4

 

Step 5

 

To reveal the final product, gently pull off the transfer tape from the decal at a 180° angle. If the decal peels off, reattach it with the squeegee.

Installation instructions step 5

 

 

HORIZONTAL WALL STICKERS INSTALLATION INSTRUCTIONS 

 

Step 1

 

Clean the surface. Ensure that the surface is dry and free from any dust or dirt.

 

If paint is fresh, wait two weeks before applying your wall decal to make sure it is dry.

 

Installation instructions step 1

 

Step 2

 

To ensure that the decal is properly positioned, attach it to the wall using small pieces of masking tape.

Installation instructions step 2

 

Step 3

 

 

Apply one strip of masking tape vertically at the center of the decal. This strip will be used as a support to keep the decal in place during the application process.

 

Installation instructions step 3

 

Step 4

 

Pull one side of the decal away from the wall, and remove the backing to reveal the sticky side of the vinyl. With scissors, cut the backing near the centre of the decal. CAUTION: do not let the exposed decal touch the wall – the back of it is very sticky. If the decal is not properly aligned on the wall, it can be difficult to reposition it without causing damage to the vinyl.

Installation instructions step 4

 

Step 5

 

While holding the decal away from the wall surface, use a squeegee (a credit card is fine) to attach the decal to the surface. Begin at the centre.

Make sure to work from top to bottom, and from the inside of the decal outward. Use firm strokes with the squeegee to force the air out from under the decal.

Installation instructions step 5

 

 

Étape 6

 

Remove the remaining backing and repeat steps 4 and 5. Note: make sure to work from the centre of the decal outward. Do not allow the entire decal to touch the wall. If lines or creases develop, gently lift and reposition the decal.

Installation instructions step 6

 

 

Step 7

 

To reveal the final product, gently pull off the transfer tape from the decal at a 180° angle. If the decal peels off, reattach it with the scraping tool.

Installation instructions step 7